Tagged: NBMA

0

Routing Notes « networknight

I have found this good article on wordpress. I thought it was good for everyone to read if they are working on taking the CCNP Routing exam. I hope this helps many people. I give credit to Longstreak for a  good write up. RTA ROUTING NOTES December 4, 2012 · by longstreak · in Networking Basics Routing Notes « networknight. Key points that I only understood fully when studying for the CCNP routing exam this time around: Redistribution: Routes are redistributed into the destination protocols topology table/database, no the Routing Information Base (RIB). Routes must have made it into the RIB from the source protocol to be considered for redistribution into...

RTA LOGO 0

EIGRP Frame Relay Test Lab

I was able to successfully complete the EIGRP Labs that were included with the CCNP Route CBT Nuggets. I know my hurdle was the frame relay. I decided to make a large topology within GNS3. The lab was set up using a similar IP addressing scheme. It consisted of 4 routers connected to a frame relay cloud. Each router had a single Serial Interface connected to the cloud. I used 3 sub interfaces on each router ending in a total of 6 DLCI’s for Full Mesh Topology.  I set up the wan links using point to point sub interfaces and...

0

My CCNP Certification Progress

CCNP Route Part 2   It has been a couple of days since I started my CCNP Route studying and I have hit my first stumbling point.  It wasn’t the configuration of  EIGRP as a whole. I was able to remember and grasp the concepts of Passive Interfaces, Network Commands, Un-Equal Cost Load Balancing as well as authentication and utilizing the bandwidth percent command. The problem that I was having was the configuration of frame relay. The frame relay lab topology I was working with has 3 routers in a hub and spoke topology. The simulated wan backbone was a...